Charging With The Supply Unit; Charging In The Smartclean System (Specific Types Only); Using The Appliance; Switching The Appliance On And Off - Philips 9000 Série Mode D'emploi

Charging with the supply unit

1 Make sure the appliance is switched off.
2 Put the supply unit in the wall socket and put the small plug in the
appliance (Fig. 15).
3 After charging, remove the supply unit from the wall socket and
pull the small plug out of the appliance.

Charging in the SmartClean system (specific types only)

1 Put the small plug in the back of the SmartClean system.
2 Put the supply unit in the wall socket.
3 Press the top cap to be able to place the shaver in the holder
('click') (Fig. 16).
4 Hold the shaver upside down above the holder. Make sure the
front of the shaver points towards the SmartClean system (Fig. 17).
5 Place the shaver in the holder (1), tilt the shaver backwards (2) and
press down the top cap to connect the shaver ('click') (3) (Fig. 18).
Note: The battery symbol starts to flash to indicate that the appliance
is charging. When the battery is fully charged, the battery symbol
lights up continuously.

Using the appliance

Note: This appliance can only be used without cord.

Switching the appliance on and off

-
To switch on the appliance, press the on/off button once (Fig. 19).
The display lights up for a few seconds.
-
To switch off the appliance, press the on/off button once.
The display lights up for a few seconds and shows the remaining
battery charge.
Shaving
Skin adaptation period
Your first shaves may not bring you the result you expect and your
skin may even become slightly irritated. This is normal. Your skin and
beard need time to adapt to any new shaving system. To allow your
17
English