Optional No-Light Plate Assembly - Emerson VOLTA CF590BQ00 Mode D'emploi

6. Optional Installation of No-Light Plate Assembly
NOTE: To use the No-Light Plate Assembly, the Light
Kit Assembly MUST NOT Be Installed, or Light Kit
Assembly MUST Be Removed.
6.1
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
Removal of the Shade from the Light Kit Adapter/
Light Kit Assembly:
Rotate the Shade counter-clockwise and remove from the
Light Kit Adapter/Light Kit Assembly (Figure 20).
6.2
Remove one of the three 6-32 x 3/8" Truss Head Screws
with Lockwashers in the Light Kit Adapter and loosen the
remaining two screws in the key hole slots (Figure 21).
Rotate the Light Kit Assembly counter-clockwise for
removal.
Replace the 6-32 x 3/8" Truss Head Screws with
Lockwasher previously removed and tighten all three
screws.
6.3
Disengage the fan motor assembly 2-pin wire connector
from the 2-pin wire connector of the Light Kit Assembly
(Figure 22).
Store Light Kit Assembly in a safe location for future
installation.
Tuck the fan motor assembly wires and connectors into the
Light Kit Adapter adapter prior to assembling the
no-light plate.
ROTATE
COUNTER-CLOCKWISE
Figure 20
LOOSEN TWO 6-32 x 3/8" TRUSS
HEAD SCREWS WITH LOCKWASHERS
COUNTER-CLOCKWISE
REMOVE ONE 6-32 x 3/8" TRUSS
HEAD SCREW WITH LOCKWASHER
Figure 21
FAN MOTOR
ASSEMBLY
2-PIN CONNECTOR
LIGHT KIT ASSEMBLY
2-PIN CONNECTOR
Figure 22
13
H
LIGHT KIT
ADAPTER/
LIGHT KIT
ASSEMBLY
SHADE
H
LIGHT KIT
ROTATE
ASSEMBLY
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF590