Installation; Assemble The Speakers; Speaker Setup For Htz-Bd50; Preparing The Speakers - Pioneer HTZ-BD50 Mode D'emploi

16

Installation

3
Installation
Assemble the
speakers
3

Speaker Setup for HTZ-BD50

Preparing the speakers

1. Attach the non-skid pads to the base of
each speaker stand bases, the subwoofer
and the center speaker.
For speaker stand bases:
Use the supplied adhesive to attach four
middle pads to the base (bottom) of each
speaker stand base.
For subwoofer:
Use the supplied adhesive to attach four
large pads to the base of subwoofer.
middle non-skid pads
large non-skid pads
For center speaker:
Use the supplied adhesive to attach four
small pads to the base of center speaker.
2. Attach the speaker stand bases to the stems
using the screws provided.
Once you have aligned the stem and base,
secure with the small screws at the points
shown below. Note that the speaker should
face in the direction of the base of the
isosceles triangle.
Rear
Front
small non-skid pads