Multi-Point Average - Wohler FA 410 Mode D'emploi

5.8.2

Multi-point average

Fig. 11: Average value mode,
multi-point
Fig. 12: Average value display,
multi-point

To obtain a printout, press and hold the
HOLD/MIN/MAX key.
"Print" is shown in the display.
CAUTION!
After returning to the normal measuring mode, the
average values will no longer be shown. There-
fore we recommend to print them out for docu-
mentation.

To return to the normal Measuring mode,
press the Up key.

In the normal Measuring mode, press and
hold the Up key for 2 seconds to access the
Multi-point average mode.
A dot and AVG are displayed in the top part of the
display.
The number of stored measurement readings is
displayed in the top part of the display; the
current reading is displayed in the lower part
of the display.

To save a measurement reading, press the
HOLD/MIN/MAX key.

Repeat this process at various points.

When a sufficient number of measurement
readings have been saved, press the Up key
to display the average value.
AVG flashes.

Press the Down key to toggle between the
average values of the different measured
quantities.
Operating the fan anemometer
EN
51