Safety Instructions - IFM Electronic efector190 DTA100 Notice D'utilisation

1. Safety instructions

General
Follow the operating instructions. Non-observance of the instructions,
operation which is not in accordance with prescribed use, wrong installa-
tion or handling can affect the safety of people and machinery.
The installation and connection must comply with the applicable national and in-
ternational standards. Responsibility lies with the person installing the unit.
The unit must be installed, connected and put into operation by a qualified electri-
cian as the safe function of the unit and machinery is only guaranteed when in-
stallation is correctly carried out.
Disconnect the unit externally before handling it.
The unit must be supplied with an external direct voltage of 26.5...31.6 V accord-
ing to the criteria for safe extra-low voltage (SELV).
According to the technical specifications indicated in the instructions the unit can
be operated in a wide operating temperature range. Because of the additional in-
ternal heating the housing walls can have high perceptible temperatures when
touched in hot environments.
In case of malfunction of the unit or uncertainties please contact the manufacturer.
Tampering with the unit can seriously affect the safety of people and machinery.
This is not permitted and leads to an exclusion of liability and warranty.
Radio equipment
Do not transport and store any flammable gases, liquids or explosive
substances near the unit. In general, radio equipment must not be used
in the vicinity of petrol stations, fuel depots, chemical plants or blasting operations.
Electronic devices
Operation of the unit can affect the function of electronic devices that
are not correctly shielded. Disconnect the unit in the vicinity of medical
equipment. Please contact the manufacturer of the corresponding device or equip-
ment in case of problems.
FCC Notices (USA, Canada)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions.
(1) this device my not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications made to this equipment not expressly appro-
ved by ifm electronic gmbh may void the FCC authorization to operate this
equipment.
/
READ WRITE HEAD FOR RF IDENTICFICATION SYSTEMS
DTA100
11