Additional Safety Rules - Makita 9403 Manuel D'instructions

ENGLISH
1 Lever
2 Adjusting knob
3 Dust bag
4 Dust nozzle
5 Fastener
SPECIFICATIONS
Model
Belt size .......................................................................................100 mm x 610 mm
Belt speed ....................................................................................500 m/min.
Overall length ..............................................................................353 mm
Net weight ....................................................................................5.9 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for the sanding of large surface of
wood, plastics and metal materials as well as painted
surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.43 Ohms it can be presumed that
there will be no negative effects.
The mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow trip-
ping characteristics.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

ADDITIONAL SAFETY RULES

1. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tools
may contact hidden wiring or its own cord. Con-
tact with a "live" wire will make exposed metal
parts of the tools "live" and shock the operator.
2. Hold the tool firmly with both hands.
3. Make sure the belt is not contacting the work-
piece before the switch is turned on.
4. Keep hands away from rotating parts.
5. Do not leave the tool running. Operate the tool
only when hand-held.
6. This tool has not been waterproofed, so do not
use water on the workpiece surface.
7. Ventilate your work area adequately when you
perform sanding operations.
Explanation of general view
6 Lock button
7 Switch trigger
8 Cork rubber plate
9 Carbon plate or steel plate
8.
9.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Installing or removing abrasive belt (Fig. 1 & 2)
Important:
Always be sure that the tool is switched off and
unplugged before installing or removing the belt.
Pull the lever all the way out and install the belt over the
rollers, then return the lever to the original position.
CAUTION:
When installing the belt, make sure that the direction of
the arrow on the back of the belt corresponds to the one
on the tool itself.
Adjusting belt tracking (Fig. 3)
While the belt is running, use the adjusting knob to center
the belt tracking.
Dust bag (Fig. 4 & 5)
Attach the dust bag onto the dust nozzle. The dust noz-
zle is tapered. When attaching the dust bag, push it onto
the dust nozzle firmly as far as it will go to prevent it from
coming off during operation. For the best results, empty
the dust bag when it becomes about half full, tapping it
ENB007-1 lightly to remove as much dust as possible.
10 Strap washer
11 Limit mark
12 Brush holder cap
13 Screwdriver
9403
Some material contains chemicals which may be
toxic. Take caution to prevent working dust inha-
lation and skin contact. Follow material supplier
safety data.
Always use the correct dust mask/respirator for
the material and application you are working
with.
9921
76 mm x 610 mm
500 m/min.
353 mm
5.5 kg
5