Remove Casing; Remove Radiator; Place The Control Panel On The Side - Jaga AURORA H52-TYPE11 Instructions D'installation

REMOVE CASING

Aurora is designed to be installed without having to remove the casing. if this is necessary, this can
be done by removing the thermostat head and sliding the latches to the left and right downwards.
Keep the reverse order for replacing the housing.

REMOVE RADIATOR

The complete device can be removed by pulling the snaps, located on the wall side under the grille,
firmly upwards after the hydraulic and electrical connections have been disconnected.

PLACE THE CONTROL PANEL ON THE SIDE

If it is not possible to see and operate the control panel when it is on the top, it is possible to place it
on the side of the device.
62 AURORA Installation instructions
|
jaga
Push the locks outwards to remove the
entire casing.