Jaga AURORA H52-TYPE11 Instructions D'installation page 60

06A4
Remove the cable with the plug from the device
along the top. Then cut the plug from the cable.
10A7
Connect the plug-in connector and turn until
tight.
10A9
The LEDs in the control panel will flash.
60 AURORA Installation instructions
TURN ON THE MAIN SWITCH!
= OK
MODE 1 2 3 4 5
ON/OFF = 3 Sec
|
jaga
06A5
Mount the plug-in connector on the cable of the
power supply and the cable of the device (the
plug-in connector is optional: see page 57).
10A8
Hydraulically connect the device.
If you would like to close the device on the left
side, see page 63.
Mount the thermostatic knob.
10A10
Place the grid on the device.