Activated Carbon Filter Installation - CIARRA 736N Manuel De L'utilisateur Et D'installation

Activated Carbon Filter Installation（VENT INSIDE）:
If you do not have an outlet to the outside, exhaust pipe is not required and the
installation is similar to the one shown in section "Installation (Vent outside)"
1. Activated carbon filter can be used to trap odors.
In order to install the activated carbon filter, the grease filter should be
detached first. Press the lock and pull it downward.
2. Plug the activated carbon filter into the unit and turn it in clockwise
direction. Repeat the same on the other side.
3. If replacement, please turn it in anti-clockwise direction.
NOTE:
➢ Make sure the filter is securely locked. Otherwise, it would loosen and
cause dangerous.
➢ When activated carbon filter attached, the suction power will be lower.
➢ The activated carbon filter should be changed every 3 months depending
on the conditions of us.
Installation
13
EN