Instructions For Use; Starting The Engine - Grillo DUMPER 507 2008 Mode D'emploi Et Maintenance

MACHINE:
Clutch: Operated by hand.
Gearbox: With oil-immersed gearbox, 4 forward + 3 reverse speeds, with reverser lever.
Speeds at 3600 rpm
I II III IV
1 2,6 4,2 11
PTO: 965 rpm (clockwise rotation)
Traction: with rubber crawler tracks
Safety device: The machine is constructed to safety regulations.
The machine stops when the handlebar is released.
Steering: by means of "patented" oil-immersed clutches combined with brakes.
Load bed dimensions: 1050 x 700, openable sides 200.
Body "DUMPER" capacity: 233 l.
Weight with petrol engine: 240 kg.
Load capacity on level ground: 500 kg.
Load capacity on slopes of 20%: 410 kg.

INSTRUCTIONS FOR USE

Checks before starting.
– To check the engine oil, remove the cap following the instructions in the engine manual.
5).
pressed air; it must be replaced if seriously clogged.
– Make sure that the gear lever is in neutral position.
backing off the lock-nut and tighten the crawler stretcher bolt.

STARTING THE ENGINE

After making the checks described:
Open the fuel tap and engage the choke (for petrol engines).
Operate the extra fuel lever and press the decompressor lever on the head of the engine until it remains
down, as indicated in the engine manual (for Diesel engines).
Start the engine by pulling the pull-start knob sharply.
After the engine has started, disengage the choke (for petrol engines) and gradually return the throttle
close to the idling position.
Allow the engine to warm up for a few minutes before starting work, and to allow proper running-in do
I R II R III R
1 2,6 3,6
9
-