Important Safety Measures - SOLIS X-CHANGE MIXER 8351 Mode D'emploi

▲

IMPORTANT SAFETY MEASURES

Please read this manual carefully before using your Solis X-Change Mixer to
get familiar with your appliance and be able to operate it safely. We recom-
mend you safely keep this manual and, should you pass the appliance on,
hand it over to the new owner.
When using electric devices, consider the following cautionary measures for
your own safety:
1. To avoid electric shock, neither the motor unit nor the power cord and plug must
come into contact with water or other liquids. Water might penetrate the hous-
ing and damage the appliance. Should the appliance resp. the power cord or plug
come into contact with liquid, use dry rubber gloves to immediately pull the
power plug from the socket.
2. Before use, check whether the voltage stated on the appliance matches your
mains voltage.
3. During operation, the blending jar must be placed on an even, stable and dry
surface like a table or work surface. The appliance might vibrate or shift during
operation, therefore you should refrain from using the blender near a table edge
and hold the blending jar tight. The appliance is not suitable for outdoors use.
4. Do not let the power cord hang over table edges to avoid it being pulled down.
Ensure that it does not come into contact with hot surfaces like f.e. a hot stove
top or a heater. Keep the power cord clear from the appliance itself. Always com-
pletely unroll the cord before connecting the plug.
5. Keep the appliance clear from hot gases, hot ovens or other heat emitting ap-
pliances or heat sources. Never use the appliance on a wet or hot surface. Do
not place the appliance near moisture, heat or open flames. Keep the appliance
clear from moving parts or appliances.
6. Never carry or pull the appliance by the power cord and do not place anything
on the power cord.
7. We advise against using an extension cable with this appliance. Do not place the
appliance directly beneath a power socket.
8. Always pull the plug when the appliance is out of use or unsupervised or when
the appliance is being assembled or taken apart or when changing attachments
resp. cleaning the blender. We recommend using a residual current device
(RCD-safety switch) to provide additional protection when using electric devices.
Using a leakage current circuit breaker with a leakage current of max. 30 mA is
advisable. Your electrician can offer professional advice.
9. Only plug the power plug into the socket when the appliance has been assem-
bled and the attachment has been mounted.
52