Crevice Tool - Beko VCO 42701 AB Mode D'emploi

3 Usage
Dust brush
1. Grasp it from the dust brush area and pull it
backwards slowly.
– A click will be heard, indicating that the
button on the body has seated into its slot.
2. Attach the end of the handle or the telescopic
tube (13) to the inner side of the upholstery
tool.
– You can now start vacuum cleaning.
3. Pull the accessory to remove it when the
process is complete.

Crevice tool

1. If the accessory is on, press the button found on
the body and push it slightly to close.
– It clicks.
2. Attach the end of the handle or the telescopic
tube (13) to the inner side of the upholstery
tool.
– You can now start vacuum cleaning.
A
WARNING: The crevice tool must
be adjusted to remain outside.
3. Pull the accessory to remove it when the
process is complete.
A
WARNING: Do not make cleaning
by using the handle' s (15) end part.
Vacuum Cleaner / User Manual
3.9 Switching off the vacuum
cleaner and parking feature
1. Switch off the appliance with the on/off button
(1) and unplug it.
2. Press the cable winding button (3) to wind the
cable inside the appliance.
Vertical parking feature
Attach the hook of the parquet/carpet brush (9) to
the parking groove located at the bottom part of
the appliance.
Horizontal parking feature
Attach the hook of the parquet/carpet brush (9) to
the parking groove located at the rear side of the
appliance.
9 / EN