MRA GSF650S/SA 2009 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Screen
1 Edge protection profile,
2 Clamp sleeves
2 M5 x 35 screws
2 Plastic washers
2 10mm spacers
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the mirrors.
3. Remove the plastic rivets by pushing in the pins [Fig. 1].
4. Remove the two screws [Fig. 1].
5. Pull the fairing backwards and detach the plug from the dash [Fig. 2].
6. Remove the screw [Fig. 3].
7. Pull the fairing upwards and forwards, and pull the coated part out towards the front [Fig. 4].
8. Turn out the fastening screws on the fairing screen, remove the fairing screen, and remove
the rubber nuts.
9. Position the rubber grommets into the
washers 6, spacers 7 and original rubber nuts onto the screen [Fig. 6].
10. Position the MRA-Screen
11. Fit the parts back on that you dismantled in points 2 to 6 in reverse order.
12. NOTE! Insert all the tabs back into the grooves.
13. Fit the mirrors and tighten the screws at 6 Nm.
14. Fit the edge protection strip across the whole exposed edge on the fairing screen (not onto
the adjustable part), and cut off any excess.
15. Slide the clamping sleeves over the ends of the edge protection strip and gently squeeze
with combination pliers enough to clamp in the protection strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
and fasten with the screws prefitted [Fig. 7].
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
GSF650S / SA 2009
Article No..
--- 3mm hex socket
--- 4mm hex socket
5mm hex socket
---
PH2 Phillips screw driver
10642
Combination pliers
10635
Torque spanner
10633
Ratchet
MRA-Screen [Fig. 5]. Prefit the screws 5 with the
3
Required tools