Warn 86386 Instructions D'installation page 9

13. Figure 17 shows the locating pin and the
position of the bail latch.
14. The winch fairlead support plate that was
earlier attached can now be finished being
installed. Take the fairlead roller and attach to
the front of the winch mount and bracket using
the last two remaining M10 x 30mm long Bolts.
Do not tighten. See figure 18.
15. Make sure that the winch mount hole are
aligned with the support bracket holes. In
Figure 19 and 20 you can use the winch mount
bolts to help align them. Tighten all the support
plate and fairlead roller fasteners at this time.
WARN® INDUSTRIES PAGE 9
Figure 17
Figure 18
Figure 19
86388A0