Installing Extraction Arm Base Assembly - Miller FILTAIR Manuel Du Propriétaire

5-4. Installing Extraction Arm Base Assembly

.
After installing extraction arm on cart,
remove pin so arm moves freely.
Cart
! Turn Off and disconnect in-
put power.
.
Stabilize fume extractor by
locking front wheels (casters).
1 Base Assembly
2 3/8 in. Screw
3 3/8 in. Flat Washer
Place base assembly on cart. Se-
cure base assembly with supplied
hardware. Tighten hardware to 3.0
ft lb (4.0 N⋅m).
Tools Needed:
9/16 in.
2
3
1
260 882-B / 264 213-A / 260 983-A
OM-260 545 Page 17