Table des Matières
Publicité
4-1. Introduction
The Capture series of weld fume collectors incorporates a high-volume vacuum system that uses a high efficiency, nanofiber-media cartridge filter
to collect airborne weld fume particles. Weld fumes are captured at the source by a unit-mounted extraction arm. The extraction arm uses gas-shock
assisted friction joints and flexible tubing to ensure the hood is placed near the source of the fumes.
The weld fumes are first drawn into the arm through a mesh screen which prevents large sparks from passing into the filter housing. The fumes then
pass through the filter where particles are filtered from the air. Cleaned air flows through the center of the filter and into the blower housing. The blower
housing discharges the clean air from the perimeter of the hood (to establish the fume capture zone) and from the back of the unit.
An adjustable air control knob allows the user to regulate the amount of clean air discharged from the perimeter of the hood to create the most effective
fume extraction zone for the work environment.
The weld fume collector includes a semi-automatic filter cleaning system to remove particles from the filter. When the Cleaning Cycle is initiated either
manually or automatically, compressed air removes particles from the filter. The particles then fall into a collection tray at the bottom of the unit.
The weld fume collector comes partially assembled and can be used with a 10 Ft. (3 m) or 12 ft. (3.7 m) extension extraction arm.
3
5
4
6
4-2. Serial Number And Rating Label Location
The serial number and rating information is located on the front of the unit. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
4-3. Fume Extractor Specifications
Input Power
Nominal Air Flow
460 Volts AC, 6.2 A
Or
(425 liter/sec)
575 Volts AC, 5.2A
SECTION 4 − SPECIFICATIONS
11
10
8
9
7
Motor
900 CFM
5 HP
(3.73 kW)
2
5
Filter Area
Sound Level
77 dBa
2
452 ft
AMCA Tested
2
(42 m
)
Sound Level At
5 ft (1.5 m)
1
Hood
2
Capture Arm
3
Air Baffle and Spark Guard
4
Filter
5
Air Discharge Vent
6
Particle Tray
1
7
Caster w/Brake
8
3/8 NPT Compressed Air
Fitting
9
Power Receptacle
10 Push bar
11 Air Control Knob
Weight
Dimensions
Cart:
590 lb (268 kg)
Cart w/XD-10 Arm
Model:
48 x 31 x 39 in.
(102 x 79 x 99.1 cm)
685 lb (311 kg)
Cart w/XD-12 Arm
Model:
695 lb (315 kg)
OM-260 545 Page 13
260 889-B
Publicité
Table des Matières
