KOBE IS-124 Série Notice D'installation Et Mode D'emploi page 14

To Replace Light Bulb
&$87,21
HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL.
:
NOTE: DO NOT TOUCH HALOGEN LIGHT WITH BARE HANDS, WHICH MIGHT CAUSE OVER
HEAT AND SHORTEN THE LIFT OF LIGHT BULBS.
c c c c
1. Make sure all controls are OFF, and range hood is unplugged.
2. Place the flat-head screwdriver into the groove between the halogen light glass covering and
the housing c.
3. Gently separate glass covering from the housing d.
4. Gently pull out the defective light bulb e and discard.
maximum.
5. Wear a glove or use a cloth to hold the new light bulb and push securely into light socket.
NOTE: DO NOT PUSH TOO HARD OR YOU MAY BREAK THE BULB CONNECTOR.
6. Put back halogen light glass cover f.
7. Plug back power cord and turn on range hood to test for operation.
d d d d
12
e e e e
Light bulbs should be 12V 20W
f f f f