Perel Tools EDL2 Notice D'emploi page 3

1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! The EDL2 is a powerful rechargeable flashlight with 9 LEDs. Its directional head and
magnetic base make this a flexible lighting tool. Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• A qualified technician should repair this device.
• Do not open the flashlight to avoid electroshocks.
• Keep the flashlight, the battery charger and the car plug away from rain and moisture.
• Make sure the flashlight, battery charger, the cable and the rechargeable battery are not damaged or deformed
before use.
• Unplug the battery charger from the mains and disconnect from the flashlight before using or cleaning.
• Clean the flashlight regularly with a dry, lint-free cloth. Do not use alcohol or solvents.
• Charge your flashlight at least once every 3 months. After the charging process (4h), let the flashlight cool down
for 15 minutes before use. Do not charge the flashlight continuously for mode than 5 hours.
• Only charge the flashlight using the included battery charger or car plug.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. Description
1. on/off switch
2. LEDs
3. magnetic base
4. crank
5. charging indicator
6. charging complete
7. charging input
4. Charging Your Flashlight
• Battery Charger
Insert the plug in the charging input (7) and connect the battery charger or car plug to the mains or the
cigarette lighter input respectively. The red charging indicator (5) will light. Disconnect when the green
indicator (6) lights.
EDL2
EDL2 – DYNAMO MAGNETIC FLASHLIGHT
3 PEREL