Philips RQ1145 Mode D'emploi page 26

English
26
Problem
The shaver does
not shave as well as
it used to.
The shaver does
not work when I
press the on/off
button.
Specific types only:
The shaver is not
entirely clean after
I clean it in the Jet
Clean System.
Possible cause
The shaving heads are damaged or
worn.
Long hairs obstruct the shaving heads.
Specific types only: The Jet Clean
System has not cleaned the shaver
properly, because the cleaning fluid in
the cleaning chamber is soiled or the
cleaning fluid level is too low.
The rechargeable battery is empty.
Specific types only: The travel lock
is activated.
The shaving head holder is soiled or
damaged to such an extent that the
motor cannot run.
The temperature of the shaver is too
high. In this case, the shaver does not
work.
The cleaning fluid in the cleaning
chamber is soiled.
The cleaning fluid level is too low. If the
fluid volume in the cleaning chamber
drops below the minimum level during
the cleaning program, the program
aborts.The cleaning light and the
'cleaning chamber empty' symbol flash
at intervals and the holder returns to
its starting position.
You have used another cleaning fluid
than the original Philips cleaning fluid.
Solution
Replace the shaving head holder (see
chapter 'Replacement').
Clean the shaving heads by following
the steps of the extra-thorough
cleaning method (see chapter 'Cleaning
and maintenance').
Clean the shaver thoroughly before you
continue shaving. If necessary, clean and
refill the cleaning chamber (see chapter
'Cleaning and maintenance').
Recharge the battery (see chapter
'Charging').
Press the on/off button for 3 seconds
to deactivate the travel lock.
Clean the shaving head holder or
replace it (see chapters 'Cleaning and
maintenance' and 'Replacement').
Let the shaver cool down. As soon
as the temperature of the shaver has
dropped sufficiently, you can switch on
the shaver again.
Empty and rinse the cleaning chamber
and refill it with new cleaning fluid.
Refill the cleaning chamber with
cleaning fluid to a level between the
two lines (see chapter 'Cleaning and
maintenance').
Only use HQ200 Philips Cleaning Fluid.