Beurer BC 54 Mode D'emploi page 34

Selecting the user
You have 2 memories, each with 60 memory spaces, to
enable the separate storage of measurements for 2 dif-
ferent people.
To select the corresponding user memory, press the M1
memory button (for user
switched-off device. Confirm your selection by pressing
the START/STOP button
Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
1 2
• Press the START/STOP button
start the blood pressure monitor. All
11
displays will illuminate briefly.
10
The blood pressure monitor will begin
9
the measurement automatically after 5
8
7
seconds.
6
The cuff automatically inflates. The
measurement itself is taken during the inflation phase.
As soon as a pulse is found, the pulse symbol
played.
You can cancel the measurement at any time by
pressing the START/STOP button
) or M2 (for user ) on the
.
to
3
4
5
is dis-
.
• The systolic pressure, diastolic pres-
sure and pulse rate measurements
are displayed.
• appears if the measurement could
not be performed properly. Observe
the chapter „9. What if there are prob-
lems?" in these instructions for use and repeat the
measurement.
• Press the START/STOP button
off the blood pressure monitor. The measure-
ment is then stored in the selected user memory.
If Bluetooth ® data transfer is activated, data is trans-
ferred after pressing the START/STOP button
The Bluetooth ®
play. The blood pressure monitor now attempts
to connect to the app for approx. 30 seconds.
The Bluetooth ® symbol stops flashing as soon as a
connection is established. All measurement data is au-
tomatically transferred to the app. Once the data has
been successfully transferred, the device switches off.
• If a connection to the app cannot be established after
30 seconds, the Bluetooth
34
symbol flashes on
symbol goes out and the
®
to switch
.
the dis-