Cleaning And Maintenance; Technical Data - VOLTCRAFT BS-500 Mode D'emploi

SWITCHING ON AND OFF, BRIGHTNESS CONTROL
1. Turn the endoscope's control wheel clockwise, until you hear a click.
2. The endoscope base unit is now switched on.
3. Turn the wheel clockwise again, to switch on the light in the tip of the attached camera or to
increase its brightness. Turn the wheel counter-clockwise, to turn the light off or to decrease
its brightness.
4. Turn the wheel counter-clockwise until you hear it click, to turn off the endoscope base unit.

CLEANING AND MAINTENANCE

You do not need to service the product, apart from occasional cleaning. Use a soft, antistatic
and lint-free cloth for cleaning. Do not use abrasive or chemical cleaners.
Carefully rinse the gooseneck of the Endoscope with clean water, after use in liquids and dry it
before storing it in the case.
DISPOSAL
a) Product
Electronic devices are recyclable waste and must not be disposed of in the
household waste!
Please dispose of the device when it is no longer of use, according to the current
statutory requirements.
b) Batteries and rechargeable batteries
As a consumer you are required (Battery Ordinance) to responsibly dispose of all used
batteries and rechargeable batteries; it is forbidden to throw them away with the normal
household waste!
Contaminated batteries/rechargeable batteries are labelled with these symbols to
indicate that disposal in domestic waste is forbidden. The symbols for the relevant
heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (the marking can be seen on
the battery/rechargeable battery e.g. below the refuse bin symbol shown on the left).
You can dispose of your used batteries/rechargeable batteries free of charge at
your community's collection point or any place where batteries/rechargeable
batteries are sold!
You thus fulfil your statutory obligations and contribute to the protection of the
environment.

TECHNICAL DATA

Operating voltage:
Resolution:
Monitor:
Operating temperature:
Operating humidity:
Storage temperature:
Storage humidity:
Dimensions (W x H x D):
Weight:
4 x 1.5 V Batteries (Type AA)
320 x 240 pixels
6.35 cm (2.5")
-20 to +60 ºC
15 – 85 %rF
-20 to +60 ºC
15 – 85 %rF
93 x 228 x 41 mm
200 g
SUITABLE ACCESSORIES
An endoscope camera, sold separately, is needed in order to use the BS-500 endoscope base
unit. The following products are suitable for use with the base.
Flexible Endoscope Cameras
Order No: 101048
Camera Ø:
Length: 1 m
Field of view:
Depth of field:
Order No: 101054
Camera Ø:
Length: 1 m
Field of view:
Depth of field:
Semi-Rigid Endoscope Cameras
Order No: 101065
Camera Ø:
Length: 1 m
Field of view:
Depth of field: 15 – 100 mm
You can also find more accessories at conrad.com.
Impressum /legal notice in our operating instructions
These operating instructions are a publication by Voltcraft ® , Lindenweg 15, D-92242 Hirschau/Germany, Phone +49 180/586 582 7 (www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2011 by Voltcraft ®
101049 101050 101051
5.5 mm
2 m 3 m 5 m
67º
15 – 100 mm
101056 101057 101058
4 mm
2 m 3 m 5 m
56º
15 – 50 mm
101066 101067
5.5 mm
2 m 3 m
67º
101053
10 m
101059
10 m