Oregon 590181 Manuel D'instructions page 14

At the end of grinding operations, turn off the grinder, disconnect the cable from the mains, and remove the grinder, placing it in a safe
place, away from children.
N.B. If the chain depth gauge is too high with respect to the tooth (usually after 2/3 grinding operations), lower it using a flat file (photo
13). For the height of the depth gauge, consult the chain table enclosed at the end of the handbook (column M).
N.B.
- do not use cooling fluids while grinding
- if, when you turn the switch to "1", the grinder does not start, and if when the switch is in the "0" position the grinder does not stop,
promptly disconnect the power cable from the mains
- if the wheel is banged or hit by accident during grinding, follow the instructions provided in paragraph ASSEMBLY AND WARNINGS
ABOUT THE GRINDING WHEEL
TROUBLESHOOTING:
- The machine does not start:
- check that the plug is perfectly connected to the outlet
- check that the power cable of the machine is not damaged
- check that the outlet is energized
- check that no fuses have blown in the outlet
- check that the automatic circuit-breaker has not tripped.
If, after these operations, the failure to start can be attributed to the machine, have it checked by an authorized service center.
- The connection of the machine to the mains makes the automatic circuit-breaker trip:
- contact an authorized service center.
- The machine's electrical motor is overheated:
- check that the voltage indicated on the data plate meets the mains voltage
- comply the max. time (15 min.) recommended for continuous operation
- check that la wheel does not block during grinding
If the problem persists, contact and authorized service center.
- The direction of rotation of the wheel is the opposite of that indicated on the machine:
- contact an authorized service center
- The machine shows signs of anomalous vibrations:
- check that the machine is secured to the work bench
- check that the motor unit is secured to the base unit
- check that the wheel is properly installed on the relevant centering hub
If the problem persists, contact and authorized service center.
MAINTENANCE:
- always disconnect the plug from the socket before carrying out any maintenance, lubrication or cleaning operations
- the grinder must be kept clean, in order to make safety instructions and plates clearly legible. Clean it using a rag or a swab.
- do not use compressed air, that is likely to bring the metal dust in positions where they cannot be reached, damaging essential components
of the grinder.
DEMOLITION:
590181
The MINIGRINDER 106550 has been fabricated with 90% recyclable materials. Therefore, if the grinder must be deactivated, do not
abandon it. Take it to your dealer who will store or dispose of it correctly.
WARRANTY:
- the validity of the warranty on this product is subject to the recognition of the country of sale. To be valid, any claim must be
accompanied by a copy of the purchase documents (invoice or cash voucher). For any repairs, the machine must be sent, carriage
free, to your dealer.
- The warranty will be void if:
a. the grinder has been tampered with;
b. the grinder has not been used according to this manual;
c. non-original and/or unauthorized parts, tools, or grinding wheels have been fitted on the machine;
d. the grinder has been connected to voltage values other than the one stated on the serial number plate.
14