How To Remove And Install: Door - AEG BEB230010M Mode D'emploi

9.3 How to remove: Grill
WARNING!
There is a risk of burns.
Step 1 Turn off the oven and wait until it is cold
to clean it.
Remove the shelf supports.
Step 2 Grab the grill corners. Pull it forwards
against the spring pressure and out of
two holders. The grill folds down.
Step 3 Clean the oven ceiling with warm water,
a soft cloth and a mild detergent. Let it
dry.
Step 4 Install the grill in the opposite sequence.
Step 5 Install the shelf supports.

9.4 How to remove and install: Door

You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
Step 1 Fully open the door.
Step 2 Lift and press the clamping levers
(A) on the two door hinges.
Step 3 Close the oven door to the first opening position (approximately 70° angle). Hold the door at both
sides and pull it away from the oven at an upwards angle. Put the door with the outer side down on
a soft cloth on a stable surface.
Step 4 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
Step 5 Pull the door trim to the front to re‐
move it.
Step 6 Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
74 ENGLISH
CAUTION!
Carefully handle the glass,
especially around the edges of
the front panel. The glass can
break.
A
2
B
A
1