Control Panel Lock; Practical Advice On Using The Appliance; Switching Off The Hob; Demo Mode - SCHOLTES CI 96 I W Mode D'emploi

To cancel a programme, follow the above
GB
instructions. At step 2, press the
duration decreases progressively until it reaches 0
and switches off. The programme resets and the
display exits programming mode.
Timer
The hob must be switched on.
The timer can be used to set a duration up to 99
minutes.
1. Press the programming button until the timer
indicator light is illuminated.
2. Set the desired duration using the
buttons.
3. Confirm by pressing the
The timer begins counting down immediately. When
the time has elapsed, a buzzer will sound (for one
minute).

Control panel lock

When the hob is switched on, it is possible to lock
the oven controls in order to avoid accidental
changes being made to the settings (by children,
during cleaning, etc.). Press the
the control panel: the indicator light above the button
will switch on.
To use any of the controls (e.g. to stop cooking), you
must switch off this function. Press the
for a few moments, the indicator light will switch off
and the lock function will be removed.

Switching off the hob

Press the button to switch the appliance off.
If the control panel lock has been activated, the
controls will continue to be locked even after the hob
is switched on again. In order to switch the hob on
again, you must first remove the lock function.
"Demo" mode
It is possible to set the hob to a demonstration
mode where all the controls work normally but the
heating elements do not switch on. To activate the
"demo" mode the hob must be switched on, with all
the hotplates switched off.
• Press and hold the
simultaneously for 6 seconds. When the 6
seconds have elapsed, the ON/OFF and
CONTROLS LOCKED indicator lights will flash for
32
- - - - -
button: the
- - - - - + + + + +
and
button.
button to lock
button
+ + + + + - - - - -
and buttons
one second. Release the
press the button;
• The display will show the text DE and MO and the
hob will be switched off.
• When the hob is switched on again it will be set to
the "demo" mode.
To exit this mode, follow the procedure described
above. The display will show the text DE and OF
and the hob will be switched off. When it is next
switched on, the hob will function normally.

Practical advice on using the appliance

! Use cookware made from materials which are
compatible with the induction principle
(ferromagnetic material). We especially recommend
pans made from: cast iron, coated steel or special
stainless steel adapted for induction. Use a magnet
to test the compatibility of the cookware.
SUITABLE
*
Cast iron
Enamelled steel
Ceramic, non magnetic Stainless steel
Special stainless steel
In addition, to obtain the best results from your hob:
• Use pans with a thick, flat base in order to fully
utilise the cooking zone.
• Always use pans with a diameter which is large
enough to cover the hotplate fully, in order to use all
the available heat.
• Make sure that the base of the cookware is
always clean and dry, in order to fully utilise and
extend the life of both the cooking zones and the
cookware.
• Avoid using the same cookware which has been
used on gas burners: the heat concentration on
gas burners may distort the base of the pan,
causing it not to adhere correctly.
+ + + + + - - - - -
and buttons and
UNSUITABLE
Copper,
Aluminium, Glass, Earthenware,