Peg-Perego carrello duette piroet Notice D'emploi page 15

_ For new born babies it is
recommended to use the backrest
in the most reclined position.
_ WARNING: do not use the rain canopy
(if present) in interiors and check the
child is not too hot; do not leave near
sources of heat and keep away from
cigarettes. The rain canopy must not
be used on a stroller without a hood
or parasol it can attach to. Use the rain
canopy only under adult supervision.
Check the rain canopy does not
interfere with any moving mechanism
in the chassis or stroller. Remove the
rain canopy before folding the chassis
or stroller.
Duette/Triplette Piroet + Car Seat:
is approved for children from birth
up to 13 kg of weight.
When used in combination with
the car seat, this product does not
replace a cot or a bed.
Should your child need to sleep,
then it should be placed in a
suitable pram body, cot or bed.
Duette/Triplette Piroet + Pram
Body:
is approved for children from birth
up to 9 kg of weight.
_ WHEN USED WITH ONE PRAM BODY
(WITH NO SEATS), we recommend
INSTALLING THE PRAM BODY
ON THE BASE CLOSEST TO THE
HANDLEBAR.
When used in combination with the
pram body: this product is suitable
for a child who cannot sit up by
itself, roll over and a cannot push
itself up on its hands and knees.
Maximum weight of the child: 9 kg.
The carrying handle (if present)
should be left outside the pram
body and out of the child's reach
during use.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 FITTING THE WHEELS: With the chassis closed, fit the
front wheels by inserting them until they click (fig_a)
and then proceed similarly with the rear wheels until
they click (fig_b).
2 OPENING: activate the brake on the folded chassis.
Raise the handlebar in the direction of the arrow
(fig_a) and lock it until the final click (fig_b).
3 BRAKE: to activate the brake on the chassis, push down
with your foot on the brake bar located on the rear
wheels, as shown by the arrows in the figure.
4 Check that the opening is correct, as in the figure.
5 BASKET: Insert the support tube into the fabric loop
on the back of the basket, with the two silver buttons
facing downward (fig_a). Press the silver buttons under
the metallic tube and slide it into its seats on the back
of the chassis (fig_b).
6 IMPORTANT! Fix the three lower eyelets of the basket
to the three grey buttons located above the rear bar.
Please note that the eyelets open (fig_a).
Fix the two upper eyelets of the basket to the two
grey buttons on the sides of the basket tube supports.
Please note that the eyelets open (fig_b).
7 Fix the two upper eyelets of the basket to the two grey
buttons on the front supports of the basket (fig_c). Run
the two zip strips, upper and lower, respectively over
and under the front chassis tubes (fig_d).
8 Join the zip strips together and pull the zip shut (fig_e).
9 Fix the four side Velcro strips to the basket tubes, as
shown in the figure.
10 SWIVEL WHEELS Lower the lever to lock the front
wheels (fig_a). Move the lever in the opposite direction
to make the wheels swivel (fig_b). The rear wheels are
fixed.
11 SIDE HANDLES: the complete chassis may be lifted
using the central external handles (fig_a) and the rear
handlebar (fig_b). The chassis must be lifted by two
people.
Figure C shows the correct way to lift it.
12 WHEEL REMOVAL: To remove the rear wheels: pull the
pivot outwards and remove the wheel as shown in the
figure (fig_a).
To remove the front wheels: press the tab as shown
and remove the wheel (fig_b).
13 FOLDING: apply the brake and release the seats.
To close the chassis, push the side button, lift both
levers on the handlebar (fig_a) and rotate it forward
(fig_b) until it closes (fig_c).
You can fold up the frame without releasing the Pop-
Up seats. To do this, lower the backrest of both seats
fully forward.
SERIAL NUMBERS
14 Information about the production date can be found
on the Duette Piroet / Triplette Piroet.
_ The product name, production date and serial number
of the chassis.
This information is required for any complaints.
GANCIOMATIC SYSTEM
Ganciomatic is a fast and practical system that allows
you to attach the pram body, the car seat and the seat to
the Ganciomatic base of the chassis in one quick step.
WARNING:
mechanisms have been secured before use.
Ensure the seat and car seat fastening mechanisms
have been properly secured before use.
ALL THE POSSIBLE COMBINATIONS:
DUETTE PIROET CHASSIS
15 DUETTE PIROET CHASSIS + 2 SEATS
Figures A, B and C show the positions in which the
seats may be installed.
- 15 -
Ensure all the fastening