Operator's Menu; Change Primary Air Shut-Off Time With Sub-Menu Pas; Select Control Curve With Sub-Menu Typ; Acoustic Signal On/Off With Sub-Menu Bep - Olsberg OEC II Instructions

Operator's menu

The following settings can be made in the operator's
menu:
● Primary air shut-off time 1 - 60'
● Select control curve 1 - 5
● Acoustic signal on/off
● Display brightness
● Display in standby mode on/off
● Code word change
● Control parameter for convection air
Change primary air shut-off time
with sub-menu PAS
Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until C - S appears in the display.
Press R = 15 in display (for control curve 2)
Set the desired value with P or M.
Press R to confirm.
Press P + M simultaneously to exit the menu.

Select control curve with sub-menu tYP

Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until tYP appears in the display.
Press R = 2 in display
Set the desired value with P or M.
Press R to confirm.
Press P + M simultaneously to exit the menu.

Acoustic signal on/off with sub-menu bEP

Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until bEP appears in the display.
Press R = on or off in display
Set the desired value with P or M.
Press R to confirm.
Press P + M simultaneously to exit the menu.

Change display brightness with sub-menu JAS

Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until JAS appears in the display.
Press R = 0 - 5 in display
Set the desired value with P or M.
Press R to confirm.
Press P + M simultaneously to exit the menu.

Display in standby mode on/off with submenu Sut"

Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until Sut appears in the display.
Press R = on or off in display
Set the desired value with P or M.
Press R to confirm.
Press P + M simultaneously to exit the menu.

Code word change with sub-menu EPS

Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until EPS appears in the display.
Press R = -2 in display
Set the desired value with P or M.
Press R to confirm.
Set the desired value with P or M.

Control parameter for convection air

Press P until St (desired room temperature) appears
in the display.
Press R to confirm.
Set the desired value with P or M.
Press R to confirm.
Press P until SH (switching hysteresis) appears in the
display.
Press R to confirm.
Set the desired value with P or M.
Press R to confirm.
Set the desired value with P or M.
27