Maintenance And Storage - Ribimex Ribiland PR4EN1ELEC Manuel D'instructions Et D'utilisation

1. The grass trimmer is equipped with a semi-auto type nylon line head that allows the operator to
advance the line without stopping the engine.
2. When the line becomes short, lightly tap the head on the ground while running the engine at full
throttle.
3 Each time the head is bumped, the line advances about 25 mm.
4. For better effect, tap the head on bear ground or hard soil.
5. Avoid bumping in thick, tall grass or soft ground.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that switch is off and tool's plug is
disconnected from its power supply.
6.1- Maintenance
- Always wear gardening gloves when handling or working near the sharp blades / chain.
- Check your machine regularly before starting any work. Check the machine carefully and replace
worn or damaged parts for safety.
- Keep all nuts, bolts and screws tight to be sure that the machine is in safe working condition.
- Damaged cutter blades / chain have to be repaired or exchanged by a qualified person before
working with the machine.
- Do not attempt to repair the machine yourself, to avoid any danger.
- Only use original accessories and spare parts.
6.2- Cleaning
a) Clean the plastic parts with a soft and clean cloth and dry the housing carefully.
Do not use aggressive cleansing agents (solvents, abrasive cleansers) or an abrasive sponge or any
sharp objects.
- Do not use any caustic chemicals to clean the plastics parts.
- Never put or immerse the product in water or any liquid, and ensure that water does not penetrate
the tool. Never splash with water or clean with high pressure hose! Do not clean under running water.
b) After each cutting operation, clean the cutting blade with a soft brush and cloth with lubricating oil
and spray a thin layer of protective oil on the whole blade.
c) Always keep the ventilation slots in motor housing clean. Clean ventilation holes with soft brush.
6.3- Storage
- Keep product, user manual and accessories in the original packaging.
- Clean tool before storage.
- Always lubricate the cutter blade with protective oil spray before storage.
- Store the machine with the supplied cutter blade protection cover.
- It is recommended to store the product in a clean, dry location, protected from humidity, frost and
dust, and keep it out of children's reach (e.g. high or in a locked up place).
- Do not store product in temperatures lower than 0ºC (32ºF)
- Do not place or store any object on top of the product.
6.4- Disposal
- Cutting remnants: do not throw with household rubbish or in the environment. Dispose of
cutting remnants in rubbish collection centres or seek advice from your local municipality.
- Tool: do not dispose with household garbage. Do not throw into the environment.
Dispose of the product in a collection centre for waste of electrical and electronic equipment, or a
waste drop-off centre; or seek advice from your local municipality.
- Proceed with disposal of remnants, the tool, accessories and packaging according to local
regulations regarding the protection of the environment.
Page 42 / 68