Ribimex Ribiland PR4EN1ELEC Manuel D'instructions Et D'utilisation page 29

This electric tool complies with the relevant safety rules. Repairs should only be carried out by
qualified persons using original spare parts; otherwise this may result in considerable danger to
the user. The use of unauthorized parts or failure to follow the maintenance instructions may result
in injury or damage.
c) Maintain tools with care. Keep cutting tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories. Keep handles dry, clean and free
from oil and grease.
Note: Unplug power tool when not in use, before servicing and before changing accessories such as
cutting device.
3.2- Safety precautions
3.2.1- Initial preparation before operation
- When you operate the tool, always wear full-length trousers, as well as sturdy, closed footwear
that provide good support. Do NOT operate the tool wearing shorts, when barefoot or wearing open
sandals!
- Do not wear loose clothing or jewelry that can be drawn into the moving parts. Keep long hair
away from the moving parts (for ex. put it in a hair net.)
- Wear protective equipment and always wear protective goggles while operating the tool.
Wearing protective equipment such as a dust mask, non-slip footwear, protective gloves, a helmet
and hearing protection (depending on the type and application of the electrical device concerned)
reduces the risk of injury.
- When performing work that generates dust, wear a dust protective mask to prevent dust irritation.
- Each time before you use the tool, check the integrity of the product's power cord and your own
extension cord for signs of damage and ageing. Do not use the tool if the cord is damaged or worn.
- The product should only be operated when its accessories are in perfect working order.
Any damaged or defective components should be repaired immediately by a qualified technician.
Never attempt to use an incomplete, not fully assembled or modified tool.
- Under no circumstances should the tool be operated while safety devices or protective guards or
shields are damaged or if safety equipment such as protective devices is not installed.
- Only use a weather proof extension cable fitted with coupler to IEC 60320-2-3.
Only extension cords that are rated for outdoor use should be used outdoors.
Any extension cord used should have a minimum cross section of 1.5mm
should have an earth contact and water-spray shielding.
- Browse the working area to:
-- remove all objects and foreign materials that may be thrown by the tool,
-- identify hard objects or risk areas to avoid damaging the tool.
3.2.2- Before starting the product
- Local or national regulations may limit the use of the product during specific hours of the day and
only by certain users; seek information with your local authority.
- Never operate this product when you are fatigued, ill, or upset, or under the influence of
medication that may make you drowsy, or if you are under the influence of alcohol or drugs
- Only operate the product after completely assembling it.
Do NOT operate product if protective device is not fully and properly assembled!
- Before each use, check the tool for any signs of damage.
- Prior to each use, check the power cord for signs of damage. Under no circumstances should the
power cord be used if it shows any signs of damage.
- Only use splash-proof extension cord approved for outdoor use and marked accordingly.
Make a loop in the extension cord and hang into the cable holder.
- Ensure that the tool is only connected to conventional sockets with a 230V alternating current
supply.
2
. All plug-in connections
Page 29 / 68