Condenser Cleaning; Removing Base Grille - Jennair JUCFP242HL11 Instructions D'installation Et Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONDENSER CLEANING:

Explosion Hazard
Risk of fire or explosion due to puncture of refrigerant
tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
1.
Remove the base grille to access condenser for
cleaning. Refer "Removing Base Grille" section.
2.
Clean the condenser coils regularly. They are located
behind the base grille. Coils may need to be cleaned
as often as every other month. This may help save
energy.

REMOVING BASE GRILLE

You must remove the base grille to access the
condenser coils for cleaning.
TO REMOVE THE BASE GRILLE:
1.
Open the double drawer door.
A. Screws
2.
Using a Phillips screwdriver, remove the two screws.
3.
Remove the base grille.
TO REPLACE THE BASE GRILLE:
1.
Open the double drawer door.
2.
Position the base grille so that both tabs align and
the base grille snaps into place. Replace two screws.
Tighten the screws.
A
CHANGING THE WATER FILTER:
The water filter is located through the base grille. You do
not have to remove the base grille in order to change the
water filter.
1.
Locate the water filter cap in the front base grille.
Rotate the cap counterclockwise to a vertical position
and pull the cap and water filter out through the base
grille.
NOTE: There will be water in the filter. Some spilling
may occur.
2.
Remove the filter cap by sliding it off the end of the
old filter. The cap will slide to the left or right.
IMPORTANT:
Do not discard the cap. It is part of your refrigerator.
Keep the cap to use with the replacement fi lter.
3.
Take the new water filter out of its packaging and
remove the cover from the O-rings.
4.
Slide the filter cap onto the new water filter. See the
illustration in Step 2.
With the filter cap in the vertical position, insert the
new filter into the base grille until it stops. Rotate the
cartridge cap clockwise to a horizontal position.
USING THE ICE MAKER WITHOUT THE WATER FILTER:
You can run the ice maker without a water filter. Your
water will not be filtered.
Slide the filter cap off the end of the water filter. With
the filter cap in the horizontal position, insert the cap
into the base grille until it stops.
IMPORTANT:
Do not discard the cap. It is part of your refrigerator.
Keep the cap to use with a replacement fi lter.
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jucfp242hm11Jucfp242hx11Judfp242hl11Judfp242hm11Judfp242hx11

Table des Matières