Care Of The Enamel Parts; Care Of Oven; Care Of The Steel Plate; Care Of The Glass Ceramic Plate - Wamsler K 118 Instructions D'installation Et D'utilisation

3.4.1

Care of the enamel parts:

Only wipe down the external surfaces when the stove is cold. Varnished surfaces should
only be washed with plain water (do not scrub). Enamel surfaces in special cases can be
cleaned with soapsuds or a bit of washing-up liquid and then wiped dry.
NOTE: Never use sponges, scouring products or any other chemical or abrasive
cleaning products!
3.4.2

Care of oven:

The oven should be cleaned when it is just warm, not after long periods but every
time it is used.
3.4.3

Care of the steel plate:

The steel sheet parts must be rubbed over with an acid-free sheet steel care product when
at blood temperature. Cleaning is then done when the stove is cold.
The special steel plates which radiate heat need to be taken care of regularly after each
time you cook. After any use which causes dampness or dirt to collect on the plate, you
must clean it. The hob plate should be cleaned when it is still lukewarm, which allows any
remaining water to evaporate and so prevents rust forming. Take care that you do not use
water to clean the stove when it is cold.
Expansion joints in the steel hob plate must always be cleaned free of adhesions,
to avoid deforming the steel hob plate and the side panels. If necessary the edge
of the cover should also be cleaned of any adhesions.
3.4.4

Care of the glass ceramic plate:

Clean the window and/or Ceran plate before first use with a clean damp cloth. Then rub a
few drops of a ceramic glass protection product onto the glass / Ceran plate with a paper
towel.
After wiping this and polishing it dry, the high quality surface is now covered with an
invisible film. The helps to keep the glass pane /Ceran plate clean and if repeated
regularly, makes it easy to clean.
3.4.5

Care of glass (window):

Before its first use, clean the ROBAX inspection glass with a wet and clean cloth, and then
put a few drops of glass–ceramics cleaner onto both sides of the glass, and spread them
with the use of kitchen paper tissues. It provides an invisible film on the valuable surface of
the Robax glass. This film helps to keep the glass clean, and facilitates regular cleaning
operations. ROBAX S for slightly contaminated surfaces – a commercially available glass
surface cleaning agent – may as well be used for the cleaning of the medium or strongly
contaminated glass surfaces of the fireplace. Towards this end, spray small quantities of
the agent to the cold surfaces,
After every period of heating you should check the stove thoroughly. If repairs or
replacements are necessary, please contact your supplier with the necessary article
Work such as installation, setup, commissioning and servicing, as well as repairs, must
only be carried out by qualified personnel (heating system or space heating technicians).
Intervention by non-qualified persons invalidates the warranty and guarantee.
PLEASE NOTE:
numbers and serial number in good time.
42