SQlab 410 Mode D'emploi page 21

Adjust the position of the brake levers to ensure that the grip is completely and correctly clamped. The brake levers
must still be quickly and easily accessible in any situation. The handlebar grip must be fully pushed onto the handlebars.
It must not protrude over the end of the handlebars under any circumstances. Before the first ride, check the proper functioning of
gearshift and brake. Make sure that the brake lever is not obstructed by the Innerbarends.
With some brake­, shift lever combinations there is not enough space for the gear shift levers, in this case the innerbarends are
not suitable and therefore cannot be mounted. In this case please make sure to contact us directly. As far as we know, this problem only
exists with Shimano groups in the entry level area.
For the further assembly of the armatures and grips on the handlebars, please observe the assembly and safety instructions provided
by the manufacturer!
Warning
When installing the armatures and grips, always observe the installation and safety instructions provided by the manufacturer!
Incorrect tightening torque and clamping of the armatures and handlebar grips in the wrong area can lead to damage of the hand­
lebars or the armatures and grips.
Note
Hinweis
Hinweis
Slide the Innerbarends completely onto the handlebar until
®
they are between brake and grips. Make sure to mount them
on the correct side (left / right) and do not adjust the grip­
ping angle either to steep, or too shallow.
Note
Hinweis
Hinweis
For an easier assembly of the SQlab Innerbarends
bon they now have a flexible clamping. The innerbarends
411 R can now be assembled and disassembled in the shor­
test time possible, without the need to remove the grips.
411 R Car­
®
®