Using The Steam Mop For Floors; Important; Using The Steam Mop For Carpets - Sunbeam 26630 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USING ThE STEAM MOP FOR FLOORS

IMPORTANT: Never use the Steam Mop without the cleaning pad properly attached
to the mop head.
IMPORTANT: ChECk ThE WATER TANk VIEWING WINDOW TO BE SURE ThERE
IS ADEQUATE WATER IN ThE WATER TANk.
1.
For best results, thoroughly sweep or vacuum floor(s) prior to cleaning with
the Steam Mop.
2.
Twist the quick-release upper cord wrap to either side and unwrap the power
cord completely.
3.
Plug the unit into a 120 V AC electric outlet. The indicator light will illuminate green.
4.
Press the steam pump switch to the ON (I) position. An audible hissing noise can be
heard as the unit heats and steam production begins. Steam will wet cleaning pad.
5.
Tilt the ergonomic handle to a 45-degree angle and clean the floor area slowly.
For best results: The cleaning pad should be changed when it gets too wet or
if it is noticeably dirty.
6.
Pay attention to the water tank's viewing window to monitor remaining water/steam.
As the water tank empties, a special water sensor will cause the unit to work
intermittently and eventually stop running in order to protect the pump inside the unit.
A vibrating sound may be heard, and the green/red indicator light will turn red. The
pump will turn OFF.
WARNING: Never leave the Steam Mop in one spot on any surface for an extended
period of time with a damp or wet cleaning pad attached as this may damage the floor
surface.
7.
Press the steam pump switch to the OFF (O) position. Unplug the Steam Mop.
8.
Refill the water tank using the water fill cup and funnel as previously described.
(See Figure 4.) The indicator light will change to green. Continue steam cleaning.
9.
When cleaning with the Steam Mop is completed, press the steam pump switch
to OFF (O). Unplug the unit from the electrical outlet.
10. Carefully remove the cleaning pad from the Steam Mop head.
CAUTION: Cleaning pad and mop head may be hot.
IMPORTANT: Do not store unit with a damp or wet cleaning pad attached.

USING ThE STEAM MOP FOR CARPETS

Your Steam Mop is designed to clean carpets or rugs that
will withstand high heat. Be sure to check the Use and
Care Instructions from the carpet manufacturer before
steam cleaning.
WARNING: The carpet glider accessory is for use on
carpeting and rugs only. Use of the carpet glider on other
floor surfaces will cause streaking and possible scratching
of the floor's surface.
IMPORTANT: Never use the Steam Mop without the cleaning
pad properly attached to the mop head.
IMPORTANT: ChECk ThE WATER TANk VIEWING
WINDOW TO BE SURE ThERE IS ADEQUATE WATER
IN ThE WATER TANk.
For best results, thoroughly vacuum the carpets or rugs prior
to steam cleaning.
1.
Place the mop head (with cleaning pad in place) on top
of the carpet glider (see Figure 5).
2.
Do not attempt to use the Steam Mop on carpet/rug surfaces without the carpet glider
in place!
CAUTION: Never use the carpet glider on surfaces that are prone to scratching.
CAUTION: The Steam Mop emits steam and creates moisture. If the Steam Mop
operates too long in one place, water marks can result.
Figure 5
Cleaning
Pad
Carpet
Glider
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

266312663226633

Table des Matières