Before Using For The First Time; Steam Mop Assembly; Operating Instructions; Filling The Water Tank - Sunbeam 26630 Manuel D'instructions

BEFORE USING FOR ThE FIRST TIME

1. Carefully unpack the Steam Mop.
2. Remove all parts from the carton and familiarize yourself with all of the components
listed. Make sure all components and accessories are present before discarding packing
materials. (See Figure 1.)
3. Following the instructions outlined in the Cleaning Pad Care & Cleaning section of this
Instruction Manual, wash the cleaning pad. During the manufacturing process the fabric
has a tendency to become flat as it picks up contaminants from the air and machinery.
Trim any loose pad threads with sharp scissors.
4. Attach the cleaning pad by fitting the mop head into the cleaning pad. Tighten the
cleaning pad by pressing the circular lock in one hand, while pulling the black drawstring
with the other. When a tight fit is achieved, release the lock to secure in place.
(See Figure 2.)

STEAM MOP ASSEMBLy

1. The Steam Mop comes in 2 pieces: pole and the lower body.
2. To assemble the Steam Mop for first time use, locate and line up the locking metal pin
on the bottom of the pole with the pin set hole on the top of the lower body.
(See Figure 1.)
3. Depress the metal pin to insert the pole into the lower body. Push firmly until the locking
pin pops up through the hole and locks into place. (See Figure 3.)
NOTE: The fit will be tight.

OPERATING INSTRUCTIONS

Filling the Water Tank

NOTE: In hard water areas, or to prevent calcium and mineral deposits from accumulating on
the heating element and mop head, you may use distilled or demineralized water in place of
tap water.
1. Always make sure the Steam Mop is unplugged.
2. Make sure the cleaning pad is properly attached to the mop head (see Figure 2) and
install following the procedure described in the Before Using for the First Time section
of this Instruction Manual.
WARNING: NEVER USE ThE STEAM MOP WIThOUT ThE CLEANING PAD
PROPERLy ATTAChED.
3. Turn the water tank cap counter-clockwise to open. Lift roped cap up and off the tank.
4. Using the water fill cup and funnel, pour one full water fill cup into the water tank.
(See Figure 4.)
CAUTION: Check the water tank viewing window to make sure water level does not
exceed the MAX fill line.
DO NOT OVERFILL.
5. Replace the water tank cap. Turn clockwise to tighten until snug.
Figure 2
Circular
Lock
Figure 3
Pin and
Pin Set Hole
6
Figure 4
Water Tank Cap
(roped)