Table des Matières
Publicité
Features of Your Steam Master
1. SPRAY MIST
Release
®
2. Covered Water Fill Hole
3. Steam Lever
4. S HOT OF STEAM
®
5. SPRAY MIST
Button
®
6. Reset Button/Light (select models only)
7. Soft Grip Handle
8. S ecure Cord
Retraction (select models only)
™
9. P ower Indicator Light / Restart Button
10. Fabric Select Dial
11. S elf Clean Button
12. S ee-Through Water Reservoir/
Maximum Fill Line
13. Soleplate
14. S torage Strip Indicator (select models only)
Anti-Calcium System (not shown - select models only)
t
F
W
r
o
ill the
ater
eservoir
1. S et the Steam Lever to
(Dry) and the Fabric-Select Dial to OFF. Make sure the iron is
unplugged.
2. Lift the Water Fill Hole Cover.
3. F ill an easy-pour measuring cup with tap water and pour water into iron water reservoir.
Do not fill water reservoir beyond maximum fill level.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water.
Hot metal parts, hot water and steam can cause injuries.
d
i
ry
roning
1. Make sure the Steam Lever is turned to the
2. Plug the cord into a 120-Volt AC outlet.
Iron
®
4
3
2
1
14
Visit www.sunbeam.ca for an Ironing Guide and Ironing Tips
Voyez le guide et les conseils de repassage au www.sunbeam.ca
(use tap water)
(Dry) setting.
8
7
5
6
11
12
13
t
s
o use the
torage
®
Strip
Indicator will turn from black to red, indicating that the iron is too hot to store. When
the iron is turned off, it will take the iron approximately 30-40 minutes for the Storage Strip™
Indicator to turn from red to black, indicating that the iron is cool enough to store.
CAUTION: The STORAGE STRIP
should always be handled and stored with care.
t
o
y
urning
FF
our
unplug the iron from the power source.
WARNING: NEVER yank the power cord when unplugging the iron. This can damage the cord.
s
y
toring
our
1. Turn off iron following instructions above. Allow the iron to cool.
Caractéristiques du fer Steam Master
1. Orifice d'atomisation SPRAY MIST
2. Orifice de remplissage à volet
3. Levier de vapeur
4. S urvapeur SHOT OF STEAM
5. Bouton d'atomisation SPRAY MIST
6. Bouton / voyant de remise en marche (certains modèles seul.)
7. Poignée à prise douce
8. E scamotage SecureCord
9. V oyant d'alimentation / bouton de remise en marche
9
10. Cadran de sélection des textiles
11. B outon d'autonettoyage
10
12. R éservoir translucide à repère maximal de remplissage
13. Semelle
14. I ndicateur de rangement Storage Strip (certains modèles seul.)
Système antitartre (non illustré - certains modèles seulement)
®
s
i
: Turn iron on. In approximately 2 minutes, the Storage
triP
ndicator
®
indicator should only be used as a guideline. The iron
c
y
i
a
aring For
our
ron
i
:
Turn the Steam Lever to
(Dry) and Fabric Select Dial to Off and
ron
i
ron
M
MD
MD
MD
(certains modèles seulement)
MC
u
Fter
se
Publicité
Table des Matières
