Publicité
Les langues disponibles
Les langues disponibles
How to check that your pet fencing system is functioning properly
●
You can check that your pet fencing system is operating correctly at any time:
− Before doing so, make sure the receiver collar is turned Off (indicator light Off).
− Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening them so
as to pinch the test lamp wires).
− Turn On the transmitter and the receiver collar.
− Walk up to the antenna wire holding the collar by the strap at the same height and orientation as if on your
pet's neck. At some distance from the wire depending on the settings, the collar should emit beep sounds then,
as you get closer to the wire, the test lamp should light up.
− Before disconnecting the test lamp, make sure the receiver collar is turned Off (indicator light Off).
Fitting and positioning the collar
●
Fitting and positioning are very important. In fact, these settings determine the correct operation of the product
(straying detection, transmission of the stimulations).
The position of the collar around the neck of the animal should be in the following way: the On/Off indicator light on
the collar is visible and is not in contact with the breast of the animal.
To achieve best results from your system, the strap must be adjusted so that the contact points are in contact with
the skin of the animal.
− If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of your pet.
Furthermore, the collar will not function correctly.
− If the collar is too tight, the animal will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your pet's neck.
If necessary, replace the short contact points with the long ones supplied with the kit (ref. § Changing the contact
points).
Getting the best results
●
The performances of your pet fencing system will be optimal if you follow these recommendations before each use:
− Make sure the collar battery is sufficiently charged: its condition affects the proper functioning of the collar. At
temperatures below 0°C, the battery is less effective than at room temperature.
− Make sure both contact points are properly tightened on the collar.
− Check the good fit and position of the collar on the neck of your pet.
Starting out with the pet fencing system
●
− Your pet will need to get used to the collar, for a few days let the dog wear the collar but do not turn it On.
− Closely watch your pet during the first days' use.
− Do not rush
So that your pet quickly makes the connection between the stimulation and his bad behaviour, his attention
must be attracted by first warning him with the beep sounds.
The flags enable your pet to visualize the area where he can move freely and the boundary he must not cross.
− Give your pet plenty of encouragement
Let your pet make his training alone to start with. After the stimulation, as soon as he learns to obey and turn
back, he should be patted; he will understand more quickly and his desire to obey will increase.
− Do not leave your pet unattended with the collar on until he is used to wearing it and you are satisfied that it is
working correctly. You should ensure that the stimulation level is adjusted correctly for your pet.
− When your pet has fully understood the connection between the stimulation and his bad behavior, you can get
on with your own jobs, but continue to praise him at other times to reinforce his grasps of the concept of
obedience.
User's guide CANIFUGUE SMALL – indice A
Chasse
Pêche
Loisir et nature
www.ducatillon.com
Jardin
9/12
Élevage
Publicité
