Proper Installation And Maintenance - Gaggenau VL 414 712 Notice D'utilisation

9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
9
WARNING
Risk of fire!
Overly greasy filters pose a risk of
catching fire! Never deep-fry or grill
next to the appliance without paying
careful attention. Clean grease
filters regularly.

Proper Installation and Maintenance

Have the installer show you the location
of the circuit breaker or fuse. Mark it for
easy reference.
This appliance must be properly installed
and grounded by a qualified technician.
Connect only to properly grounded outlet.
Refer to Installation Instructions for
details.
This appliance is intended for normal
family household use only. It is not
approved for outdoor use. See the
Statement of Limited Product Warranty. If
you have any questions, contact the
manufacturer.
Do not store or use corrosive chemicals,
vapors, flammables or nonfood products
in or near this appliance. It is specifically
designed for use when heating or
cooking food. The use of corrosive
chemicals in heating or cleaning will
damage the appliance and could result in
injury.
Do not operate this appliance if it is not
working properly, or if it has been
damaged. Contact an authorized service
provider.
8
Do not repair or replace any part of the
appliance unless specifically
recommended in this manual. Refer all
servicing to an authorized service
provider.
9
CAUTION
Grease left on filters can remelt and
move into the vent.
Hidden surfaces may have sharp
edges. Use caution when
reaching behind or under
appliance.
9
WARNING
When the hood is operated in
exhaust-air mode simultaneously with
a different burner which also makes
use of the same chimney (such as
gas, oil or coal-fired heaters,
continuous-flow heaters, hot-water
boilers) care must be taken to
ensure that there is an adequate
supply of fresh air which will be
needed by the burner for
combustion.
Safe operation is possible provided
that the under pressure in the room
where the burner is installed does
not exceed 4 Pa (0.04 mbar).
This can be achieved if combustion
air can flow through non-lockable
openings, e.g. in doors, windows
and via the air-intake/exhaust-air wall
box or by other technical measures,
such as reciprocal interlocking, etc.