Programming; Program Mode; Entering Program Mode; Exiting Program Mode - Chauvet DJ Foot-C Mode D'emploi

4. P
ROGRAMMING
Program
Mode
Entering

Program Mode

Exiting Program
Mode
Foot-C User Manual Rev. 2
Program mode is used to program for playback. In Program mode, lighting looks are
created and saved for playback. There are three parts to programming for playback.
·
Programming lights: selecting and controlling them to create looks.
·
Programming scenes: saving the looks into scenes.
or
·
Programming chases: saving the looks into steps in a chase.
The next section describes how to program lights, scenes, and chases, and how to
modify and delete scenes and chases.
Output can be adjusted in Playback mode, but the looks created in Playback mode
cannot be saved to memory.
To enter program mode, do the following:
1. Turn the board on.
2. Press and hold <PROGRAM> for three seconds.
3. The program indicator light, next to the <PROGRAM> button, will light up.
4. Release <PROGRAM>.
To exit program mode, follow the instructions below:
1. Press and hold <PROGRAM> for three seconds.
2. The program indicator light, next to the <PROGRAM> button, will turn off.
3. Release <PROGRAM>.
Page 15 of 88