Reprogramming If A Transmitter Is Faulty Or Lost; Reset The Receiver To The Factory Setting (Only I-R Marki Ws/Wsrf, Only For Qualified Personnel) - Selve i-R Marki WS Notice D'utilisation

GB Transmitter programming procedure

4.) Reprogramming if a transmitter is faulty or lost

Only use if a programmed transmitter is no longer available (faulty or lost). In order
to program a new transmitter, the receiver has to be put into reprogramming mode
by disconnecting it from the mains supply. Subsequently press the PROG button
of the new transmitter for 3 sec.. All the old transmitters have been deprogrammed.
Fuse/Hirschmann plug
3 sec. 3 sec.
5.) Reset the receiver to the factory setting
(only i-R Marki WS/WSRF, only for qualified personnel)
The factory setting means that no transmitter has been programmed and no inter-
mediate positions have been set. In order to reset to receiver to the factory setting,
the receiver has to be put into reprogramming mode by disconnecting it from the
mains supply. Subsequently press the PROG button of the sensor for 9 sec..
Fuse/Hirschmann plug
3 sec. 3 sec.
3 sec.
3 sec.
28
Transmitter
➡
Sensor
➡
3 sec.
✓
9 sec.
✓