Elica OM EOM431BL Guide D'utilisation, D'entretien Et D'installation page 12

20. Ducting version - Horizontal discharge ONLY:
Install the top cover.
Ductless (recirculating) version ONLY:
Remove the Knockout on top cover (to leave passage of
air from deflector) and install the top cover.
Note: The top cover should not be installed if is intended
to order and install the optional chimney kit
21. For Ductless (recirculating) installations
Install one charcoal filter (available as an extra kit).
22. Install metal filter and close the front door ((see
paragraph "Maintenance - Front Door" and
"Maintenance - Grease filter").
23. Check all light bulbs to make sure they are secure in
their sockets.
Turn power (On) in service panel.
Controls start flashing for about 15 secs to indicate they
are calibrating themselves, wait until flashing stops (only
Motor touch sensor key OFF (stand by) is ON - see
also paragraph "Controls").
Calibration is repeated any time the hoos is
disconnected intentionally or not from power supply (i.e.:
Black out).
Then check lights and blower operation.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house
fuse blown.
• Disconnect power supply. Check that wiring is correct.
12