Installation - Elica OM EOM431BL Guide D'utilisation, D'entretien Et D'installation

Installation

This hood is shipped ready for Horizontal discharge. To
change to Vertical discharge proceed as follows:
Note1: when proceeding keep all screws and memorize the
way all components are fixed.
Note2 - For Vertical discharge ONLY: The installation of the
Low or High Duct Cover kit is recommended.
a. open the front door and remove the metal filter (see
paragraph "Maintenance - Front Door" and
"Maintenance - Grease filter").
b. disconnect the blower molex plug from electronic box -
press on both side locks to release, and remove wiring
from blocks located on top side of the electronic box.
c. Remove the screws that fix the electronic box to the
back of the hood and release the box towards the
bottom of the motor housing, so to leave anough
clearance to handle the blower.
Warning! When repositioning check that electronic
box is fixed with screws and side hooks.
d. from the outside of the hood remove the top cover and 4
screws that fix the blower support bracket to rear/top
side of the range hood.
e. Remove the blower from the metal filter housing.
8