Important; Cleaning And Maintenance - NORAUTO 2270882 Mode D'emploi

CARRYING THE COOLER
EN
The cooler is fitted with two side handle. The handles should be used to lift and move the
cooler. It also has wheels on the back and a telescopic pull rod for easy manoeuvring.
WARNING: The lid latch must never be used to lift or move the cooler.
CAUTION: The cooler should always be lifted by at least two people.
COOLING CAPACITY CONTROL DIAL
When the cooler is connected to an AC mains supply, it can be used in three different
operating modes:
• MIN mode: the cooler consumes the minimum energy.
• ECO mode: the cooler consumes less energy.
• MAX mode: the cooler consumes the maximum energy.
TIP: It is recommended to use the ECO mode to conserve energy.
The desired cooling capacity is selected with the cooling capacity control:
• To increase the cooling capacity, turn the cooling capacity control dial clockwise.
For the maximum cooling capacity turn the cooling capacity control clockwise all the
way to the stop (MAX position).
• To decrease the cooling capacity, turn the cooling capacity control counter clockwise.
For the minimum cooling capacity turn the cooling capacity control counter clockwise
all the way to the stop (MIN position).
IMPORTANT: When the cooler is connected to the DC socket, it cools at the maximum setting
and the cooling cannot be adjusted.

CLEANING AND MAINTENANCE

• WARNING: Always disconnect the device from the power supply before cleaning or
maintenance.
• Never immerse the unit in water or other liquids.
• Wipe interior and exterior with a damp cloth and neutral cleanser.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage
the product.
• Keep the ventilation slots free of any dust and dirt, so that heat can be released and the
device is not damaged.
• Carefully wind up the power cord and store it in the power cord compartment.
• Ensure the inside is fully dry before storing when not in use.
• When not in use the cooler's lid shall be left ajar to prevent mould growth.
• Store the appliance in a cool, dry place, protected from moisture and direct sunlight.
TROUBLESHOOTING
Problem
The device is not working
(plug is inserted).
30
Possible cause
There is no voltage flowing in
the DC socket in your vehicle.
No voltage present in the AC
voltage socket.
The inner fan or the cooling
element is defective.
MIN
Suggested remedy
The ignition must be
switched on in most vehicles
to apply current to the DC
socket.
Try using another plug socket.
This can only be repaired by
an authorised repair centre.
MAX