Bond HYFP50095-11 Guide D'utilisation page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

See WARNING and Figures:
WARNING
This screen must be clear and free
of obstructions at all times to insure
proper operation.
WARNING
The burner of the firebowl must be cov-
ered by lava rocks completely. Otherwise
the flame may be extinguished. See the
Figure for the CORRECT and
INCORRECT ways for reference.
Perform leak test in a well ventilated area outside and where no source of spark can occur.
Remove battery from igniter. Open tank valve fully (counter-clockwise). Turn the on/off valve at the unit to the 'off' position
to pressurize the hose assembly. Use a soapy water solution to check all the connections leaks before attempting to light
the appliance. If a leak is found, turn the tank valve off and do not use the appliance until repairs can be made.
TIPS:
Before Starting
Cover must be removed when burner is in operation.
Firebowl and propane gas cylinder minimum
distance must be over 60"(as per the right
side photo).
TO LIGHT
Before each use, inspect the hose. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the cylinder valve on the gas tank counter-clockwise to open the gas supply.
(2) Light the firebowl as below steps:
A. Press and hold the Electric Ignitor. Meanwhile, push and turn the Control Knob counter-clockwise to the "LOW"
position. Keep pushing the Control Knob to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 45 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to
"OFF". Wait 5 minutes, then repeat the lighting procedure as above.
Caution: *If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could
accidently ignite with risk of injury.
Read the instructions thoroughly.
Check and make sure that all parts are present.
For future reference, save this instruction manual.
CORRECT
Observe flame height when lit:
Flame should possibly be a yellow/blue color
be teween 2 to 10 inches high.
8
INCORRECT

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

67518

Table des Matières