Bond HYFP50095-11 Guide D'utilisation page 7

ASSEMBLY INSTRUCTIONS
* Please keep these owner's manual for future reference.
*If you have opened the carton and removed all packages, please disregard the STEP 1. See the STEP 2
directly.
STEP 1-A. (1) Open the carton and turn it upside down, make
sure
the 4 pieces of the carton being open up as below Figure
STEP1-A .
(2) Lift off the carton carefully and be wary of the accessories
inside falling away.
(3) Take all the packing materials away except for the paper
honeycomb board rounding the top of the firebowl.
STEP 2.
(1) Check each part before using the product. Make sure the gas
supply system is turned "OFF" before assembling. See Figure C.
(2)Put the gas tank in the metal stand. Make sure the gas tank
sits on the metal stand completely. Turn the wing screw on
the outer part of metal stand clockwise to secure the gas tank
tightly. See Figure F.
(3) Locate the battery, remove the plastic cover first. Unscrew
the rubber cap of the Electric Ignitor, place a AAA battery into
the battery case. Make sure the positive pole ("+") towards the
cap. Screw the cap back to the battery case tightly. See Figure
D.
(4)
Place the lava rock averagely in the fire bowl on the
top of the firebowl. See Figure E.
** DO NOT COVER THE IGNITION SCREEN
when placing the lava rock into the fire bowl. Al-
ways keep Ignition Screen visible.
** Connect the Pressure-Regulating Valve to the gas
tank. See Figure .
G
1) Turn the cylinder valve clockwise to close the gas
supply on the gas tank.
2) Screw Regulator Coupling clockwise by hand only.
Make sure it is fastened.
STEP 1-B. (1) Turn the firebowl heads up on a flat
ground.
(2) Remove all the paper honeycomb board rounding
the top of the firebowl.
7
G