Maintenance & Service; Cleaning; Troubleshooting; Technical Specifications - Evolite MOVING BEAM 12x10 Mode D'emploi

• Maintenance & service
o Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause
greater accumulation of dirt on the fixture's optics.
 Clean with soft and dry cloth .
 Always dry the parts carefully.
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy

troubleshooting:

•
The fixture does not work, no light
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.
o
•
Not responding to DMX controller
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
o
polarity.
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
o
fixture or the previous one.
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
o
damage or interference to DMX interface circuit.
• Some fixtures don't respond to the easy controller
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.
o
•
No response to the sound
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.
o

Technical Specifications

•
TECHNICIAL SPECIFICATIONS
Model
Voltage
Power consumption:
LED
Gross Weight
Dimensions
MOVING BEAM 12X10 Manual Ver. 1.02
MOVING BEAM 12x10
110V- 250V / 50-60Hz
150W
12pcs 10w CREE RGBW high power leds
6.1Kgs
370(H) x 340(W) x 230(L) mm
DMX
Page 18