EGO CSX3000 Mode D'emploi page 46

PROBLEM
No oil
lubrication
when cutting.
"Low Oil"
indicator flashes
in red color
or showing
abnormal light
while the oil
tank filled with
oil.
"Low Oil"
indicator fails to
function when
the oil tank is
almost empty.
46
56V LITHIUM-ION CORDLESS CHAIN SAW — CSX3000/CSX3000-FC
CAUSE
◾
Oil solidification in
low temperature.
◾
The oil outlet of chain
bar is blocked.
◾
The oil tank is empty.
◾
Other.
◾
Use of the chain saw
at a particular angle
is preventing the oil
in the oil tank from
entering the oil pipe.
◾
A lubricant other than
the recommended
translucent yellow,
translucent red or
colorless translucent
oil is used.
◾
Other.
◾
The category and
color of oil cannot be
identified.
◾
A small amount of oil
still in the oil tank or
oil pipe.
◾
Other.
SOLUTION
◾
Change to the proper lubricating oil
(suitable for low temperature).
◾
Clean up the dust in the oil outlet.
◾
Fill the oil tank with bar and chain
lubricant.
◾
Contact EGO Customer Service for
repair.
◾
Place the chain saw flat and try again.
◾
Do not use black oil. Switch to a
recommended oil.
◾
Contact EGO Customer Service for
repair
◾
Use the recommended translucent
yellow, translucent red or translucent
oil.
◾
Use chain saw for a while and then
observe low oil indicator again.
◾
Contact EGO Customer Service for
repair.