EGO CSX3000 Mode D'emploi page 30

ADJUSTING OIL FLOW
◾
This saw is equipped with an Oil-
Flow Adjustment Screw, located
on the bottom of the tool, it is used
to adjust the oil flow for lubricating
the chain, bar, and cutting system
(Fig. 18). Increase or reduce the oil
flow by turning the screw (using the
combi-wrench) in the direction of
arrows marked on the housing.
LED INDICATOR ON THE CHAIN SAW
The chain saw is equipped with 2 LED indicators to indicate oil status and the charge
level of the battery pack(s).
LED indicator
Flashing red
"Low Oil"
indicator
Off
Shining
green
Battery
indicator
ATTACHING THE BATTERY HOLSTER TO THE CLIMBING HARNESS
This chain saw comes with a battery holster, it is used to carry the battery pack and
allows to be attached to the climbing
harness (not provided).
NOTICE:
Fasten the battery holster
firmly onto the climbing harness, prior to
wearing the climbing harness.
WARNING:
with quick-release function need to
be prepared to prevent the emergency
occurs.
1. Seek a preferable point for hanging this battery holster on the climbing harness,
hang the battery holster on the climbing harness by using the belt hook. (Fig. 19).
30
56V LITHIUM-ION CORDLESS CHAIN SAW — CSX3000/CSX3000-FC
Meaning
Lacking oil
Has the oil
Battery pack is adequately charged
Battery pack is nearly depleted and
needs to be charged immediately.
The Climbing Harness
18
19
Oil Flow
Adjustment Screw
Action
Fill the oil tank
/
/
Charge the
battery
Belt Hook
Climbing Harness
Battery Holster