EGO CSX3000 Mode D'emploi page 29

1. Disconnect the power plug from the
chain saw.
2. Clean the oil-tank cap and the area
around it to ensure that no dirt falls
into the oil tank.
3. Position the chain saw on its side on
a firm, flat surface, so that the oil-
tank cap is facing upwards. Rotate
the oil-tank cap counterclockwise
to remove it or use the slot-head of the combi-wrench (provided) to loosen the
oil-tank cap, when it is too tight. (Fig. 17)
4. Carefully pour the oil into the oil tank. Be careful not to let the oil spill from the
opening. Fill to the bottom of the fill neck. Wipe off any excess oil.
5. Rotate the cap clockwise to close it, place the saw upright.
NOTICE:
◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain. The recommended oil should be translucent yellow, translucent
red, or colorless translucent.
◾
Check the "Low Oil" indicator frequently never operate the chain saw with the
shortage of oil.
◾
Do not use dirty, used or otherwise contaminated oil. Damage may occur to the
bar or chain.
◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the tool for a long period of time, be sure the chain is lightly lubricated;
this will prevent rust on the chain and bar as well as the inside drive sprocket.
◾
To preserve natural resources, please recycle or dispose of oil properly. Consult
your local waste authority for information regarding available recycling and
disposal options.
56V LITHIUM-ION CORDLESS CHAIN SAW — CSX3000/CSX3000-FC
17
Oil Tank Cap
"Low Oil" Indicator
29