EGO CSX3000 Mode D'emploi page 39

REMOVE DUST
1. Disconnect the power plug, allow
the chain saw to cool and tighten
the oil-tank cap.
2. Engage the saw brake.
3. Use combi-wrench (provided) to
loosen the screw, then open the
dust removal cover (Fig. 36).
4. Clean up the sawdust and chips
accumulated in the cooling fin by
using compressed dry air, blow it
from the opposite side [air inlet]
(Fig. 37).
REPLACING THE BAR AND SAW
CHAIN
WARNING:
the chain while the motor is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the chain.
NOTICE:
When replacing the guide bar and chain, always use the specified bar and
chain combination listed in the later section "Recommended Bar and Chain for this
Chain Saw".
See related section: ASSEMBLING AND DISASSEMBLING THE BAR AND CHAIN
Please do the following:
a) Allow the chain saw to cool. Tighten the oil-tank cap to prevent oil leakage.
b) This is a good time to inspect the drive sprocket, and brake lining for excessive
wear or damage.
56V LITHIUM-ION CORDLESS CHAIN SAW — CSX3000/CSX3000-FC
Never touch or adjust
36
Dust Removal Cover
37
Air Inlet
39