Operation - Kärcher AD 3 Mode D'emploi

Accessory mount
Illustration
The accessories compartment allows the storage of
suction pipes and suction nozzles on the appliance.
Steering roller
Illustration
The steering rollers are located in the compartment
when the appliance is delivered. These must be at-
tached prior to starting up the appliance.
Flat fold filter with frame
(already installed in the appliance)
Illustration
Illustration
ATTENTION
Filters and their frames must always be inserted during

operation.

Filter intake
 Filter intake is located/sits in filter basket.
Filter basket
(with coarse dirt filter)
Suction hose with handle
Illustration
 Slide the suction hose into the connection, it will
lock into place.
In order to disconnect it, push down with your
thumb and pull the suction hose out.
*AD 3 Premium
Suction tubes 2 x 0.5 m
Illustration
 Connect both suction pipes and connect them to
the suction hose.
*AD 3 Premium
Floor nozzle
(with insert)
CAUTION
Do not use the floor nozzle to vacuum ashes.
Illustration
 Use the appropriate insert for vacuuming on hard
surfaces and carpets.
Hard surfaces: Use the insert with 2 bristles.
Carpeting: Work without an insert.
ATTENTION
Always work with the flat fold filter inserted.
 Illustration
Remove the appliance head and the filter basket.
Mount loose parts deliverd with appliance prior to
start-up.
 Illustration
Insert filter basket.
Insert and lock the appliance head.
For vacuuming ashes:
WARNING
Check whether the appliance was emptied and cleaned
during the last vacuuming cycle.
Illustration
 Connect accessories (hose only).
For dry vacuuming:
Illustration
 Connect accessories (hose, pipes, floor nozzle, in-
cl. insert).
For wet vacuuming:
Illustration
 Connect accessories (hose, pipes, floor nozzle,
without insert).
Safety Instructions for ash, wet and dry vacuuming:
Illustration
 Plug in the mains plug.
Illustration
 Turn on the machine.
Ash/dry vacuum cleaning
ATTENTION
Work with a dry flat fold filter only.
Wet vacuum cleaning
 Attach the accessories to vacuum moisture or wet-
ness to the suction tubes or directly to the handle.
Note: Empty the vacuum cleaner immediately after wet
vacuuming and let it dry. Otherwise, there is a risk of
corrosion.
Interrupting operation
 Turn off the appliance.
 Turn off the appliance and disconnect the mains
plug.
Empty the container
 Illustration
Remove the appliance head and filter basket and
empty the reservoir.
– 9
EN
Operation
Before Startup
Start up
-
-
Finish operation
15