General Warnings - Rupes LTA125 Notice D'emploi Et D'entretien

9.2465_ LTA125_set 2017_libretto AK150A ok.qxd 26/09/2017 17:11 Pagina 9

GENERAL WARNINGS

SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in
the "SAFETY INSTRUCTION" booklet which forms an integral
part of these documents; the operating instructions indicate the
additional information required specifically for use of the tool.
Never use the tools without the safety guards.
Any operations carried out on the tool must be effected with the
tool disconnected.
Before starting the tool, ensure that it is held tightly and not in
contact with the work surface.
Due to risks that may arise during polishing, we recommend the
constant use of P .S.D. (personal safety devices such as gloves,
headphones, goggles, face masks, etc.) according to laws in
force to prevent or reduce accident probability.
Warning! Carry out the lubrication process outlined on page 10,
in the maintenance paragraph. The appliance continues to work
for a few seconds after it has been switched off.
CORRECT USAGE
The tools must only be used for polishing painted surfaces,
wood, plastic, composite and similar.
Metal and materials with an asbestos content must not be
processed with these tools.
The tools must not be damp nor operated in a damp environment
for electrical safety reasons.
The tools may only be used for dry sanding.
Make sure the work piece is sufficiently fastened.
In the event of improper use, the user is fully liable for any
damages or accidents.
PARTS OF THE TOOL
1- Identification plate
2- On/off switch3- Speed control
4- Tool body
5- Velcroed disc pad
6- Polishing pad (not supplied)
7- Air inlet fitting (not supplied)
8- On-off lever safety lock
9- Back-up pad release spanner
10 - Back-up pad screw
11 - Air outlet hose/silencer
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having
been damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction
booklet;
- the available compressed air production and distribution plant is
capable of satisfying the requirements reported on the tool's
identification plate.
ASSEMBLING THE TOOL
Assemble the compressed air connection (not supplied) by
screwing it into its seating (7).
COMPRESSED AIR CONNECTION (NOT SUPPLIED)
The tool is supplied without the compressed air connection.
The user can use either a quick release coupling: or hose type
9